Introduction

Drinking water with the smell like “spoiled egg” contains hydrogen sulfide(H2S). It is a colorless gas that breaks down promptly in water with the trademark foul smell of a “spoiled egg”. this gas stays caught inside the water. At the point when the water is pumped to the surface, the hydrogen sulfide gas escapes and is along these lines easy to smell.

Drinking water with abnormal amounts of hydrogen sulfide can cause nausea and stomach torment. In any case, it is exceptionally far-fetched that a man could consume a destructive dosage of hydrogen sulfide from drinking water since water winds up noticeably unpalatable because of its upsetting taste and odor long before hydrogen sulfide achieves a harmful level. In well water, it is normally only a nuisance. Large amounts of sulfate (over 250 ppm) may have a strong laxative effect, cause drying out, dehydration and be particularly detrimental to the health of newborn children and youthful creatures. Sulfate levels of more than 250 parts per million require treatment of drinking water before utilization.

Although high concentration conventions do influence the taste of water. A concentration as low as 0.1 mg hydrogen sulfide for every liter of water (mg/l) is noticeable by smell. Most people, unaccustomed to sulfur water, find it highly unpleasant. Hydrogen sulfide can occur in deep or shallow wells and furthermore can enter surface water through springs. Shallow, inadequately built wells or those found near sewer lines or septic systems and surface water can become polluted with sewage and create issues with hydrogen sulfide.

 

WATER-TEST FOR HYDROGEN SULFIDE

It is extremely hard to test for hydrogen sulfide in a laboratory. In the groundwater hydrogen sulfide escapes very quickly and might be gone when the water reaches the laboratory. The spoiled egg resemble hydrogen sulfide is unmistakable. However, test packs are accessible for on-location hydrogen sulfide estimation.

 

HOW TO REMOVE HYDROGEN SULFIDE FROM WELL WATER?

  • • Highly advanced KATALYST LIGHT® is very efficient in removing hydrogen sulfide along with iron and manganese. KATALYST LIGHT® is the best iron and manganese removal media which can also remove low to moderate levels of hydrogen sulfide.
  • • Unlike other conventional filter media, KATALYST LIGHT® does not need very frequent regeneration, which makes it unique in the industry.
  • • Installation of KATALYST LIGHT® system for removal of hydrogen sulfide, iron and manganese is very simple and can be performed just by following a few simple instructions of the manufacturer “Watch Water®